Zinc alloy die-cast, plastic coated.
- RAL 9005 black colour SW, textured finish, epoxy resin coating.
- RAL 9006 silver colour SR, textured finish, epoxy resin coating.
Sheet steel zinc-plated, blue passivated.
Zinc-plated steel, blue passivated.
- Type DK: Operation with triangular spindle (DK7).
- Type VK7: Operation with square spindle A/F7.
- Type VK8: Operation with square spindle A/F8.
- Type VDE: Operation with double bit.
- Key GN 119.2.
By turning the latch clockwise, the stepped door locking bar engages behind the door frame and pulls the
The large tractive range of 10 mm also allows doors with sealing strips to be locked without any problems.
When selecting the clamping range A, the sealing strip may have to be taken into account.
For mounting, the door is fitted with two bore holes as shown in the outline drawing opposite, attached
at a distance of 23 mm from the door frame.
The spigot (M22x1.5) has 4 surfaces, allowing the cabinet „U“ handle also to be used with the standard
bore holes of door latches GN 119.
The locking enclosure with the preassembled operating bolt is pushed through from the front and fixed
in place with the hexagonal nut. The distance sleeve and the door locking bar is then plugged on at the
back and fixed in place with the hexagonal screw.
Latches with cabinet handle GN 119.3 are used when the application requires both a locking mechanism and
The cabinet handle with integrated lock is an attractively designed and cost-effective solution.
The locking mechanisms have a draw-in range of 10 mm. The unit is locked by turning clockwise.